YAS (Yet another shelf)

0 (likes)
546 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

Introduction A slightly over-engineered shelf.   What you need Time. The shelf prints for > 17h.Enough filament. The printer will eat > 350g.2 screws to mount the shelf at the wall: 6 x 100What you might need (optional) round bar for the rotor (8mm diameter and length 10 .. 12 cm)4 x threaded inserts M3 (e.g. Ruthex RX-M3x5,7)  Print preparation I printed the YAS upright: the fan at the bottom, the hole for the rotor at the top. Post-printing You might want to color the YAS.  You might want to add the threaded inserts.  You might want to add the rotor bar.   Usage The YAS can be used to install the Bosch charger BCS220 holder. Or you design your own holder. The top plate's dimensions are 200 x 120 mm. The threaded inserts are placed at 150 x 102 mm - seen from the center of the plate.   Disclaimer Neither mechanical nor thermal tests have been done. It is unknown how much load the shelf can take. This “thing” has been published so that it can be used and re-mixed by anyone. Especially no experience has been gathered how the thing behaves if it is used for devices which can get hot. Use at your own risk. 

About the author:
jurgenopschroef
Hi, my family and I live in a small town in Germany next to the Dutch border. Greetings from Straelen Juergen

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.